Sanyo PDP42H2A - Manual (Page 7)

7
PREPARATION
NAME OF EACH PART OF PLASMA MONITOR
NOTE:
This Plasma Monitor detects internal temperature and automatically
controls operating power of Cooling Fans.
q Cooling Fan
Back
e
Speaker Output Terminals (Left Side)
(Refer to the Optional Speakers's Installation manual.)
t Terminals and Connectors (Bottom Center)
(Refer to P12)
w Terminals and Connectors (Left Side)
(Refer to P10)
q
w
y t
e
r
u
✽
✽ Terminals for Service
These terminals cannot be used in this equipment.
u Speaker Output Terminals (Right Side)
(Refer to the Optional Speakers's Installation manual.)
y Power Cord Connector
r Terminals and Connectors (Bottom Left)
(Refer to P12)
i
i RS232C Terminal and Optional Net Organizer & switch
(Right Side)
(Refer to P11) This Plasma Monitor can be installed in two ways,
normal (horizontal) and vertical.
CAUTION:
DO NOT INSTALL UNSPECIFIED DIRECTION, OR
COOLING AIR CIRCULATION IS PREVENTED AND
IT MAY RESULT IN FIRE HAZARD.
INSTALL PLASMA MONITOR IN PROPER DIRECTION
Front Controls should
be located lower.
Horizontal Vertical