Sharp AR-BC260 - Manual (Page 73)

4-5
4
REVERSING SINGLE PASS FEEDER
The reversing single pass feeder can be used to automatically feed originals for continuous copying. Both sides of
two-sided sheet originals can be scanned without having to manually turn the originals over. This feature is
convenient for making copies of a large number of originals.
Acceptable originals
When the reversing single pass feeder is used, up to 40 originals of the same size can be set in the feeder (maximum
stack thickness of 11/64" (4 mm), or 30 originals of weight 24 lbs. (90 g/m
2 )).
■ ■ ■ ■ Size and weight of acceptable originals
Notes on use of the reversing single pass feeder
●Use originals within the specified size and weight ranges. Use of originals out of the specified range may cause
an original misfeed.
●Before loading originals into the document feeder tray, be sure to remove any staples or paper clips.
●If originals have damp spots from correction fluid, ink or glue from pasteups, be sure they are dried before they
are fed. If not, the interior of the document feeder or the document glass may be soiled.
●To prevent incorrect original size detection, original misfeeds or smudges on copies, use the following as a
guide for feeding originals.
Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink
ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be
damaged, crumpled or folded or have loosely pasted paper on them or cutouts in them.
15 lbs. or 56g/m 2 24 lbs. or 90g/m 2
2 2
Original size:
(148 x 210 mm)
5-1/2" x 8-1/2"
or A5
11" x 17"
or A3
(297 x 420 mm)
Weight (thickness):
g/m ... Weight of a sheet of paper of 1 m
ApollonII_general-copy_SEC.book 5 ページ ２００４年９月６日 月曜日 午後４時５７分