Sharp AR-BC260 - Manual (Page 76)

4-8
SELECTING THE ORIGINAL SIZE
When the correct original size is not detected or the original size is not displayed, you can manually specify the
original size.
By causing the machine to recognize the original size, you can have the automatic ratio selection function (page 5-
12) automatically set a suitable enlargement or reduction ratio for the selected paper size.
Place the original in the document feeder tray or on the document glass and then follow the steps below.
1 Touch the [ORIGINAL] key.
2 Enter the original size.
If the original size is a standard size, touch
the appropriate original size key.
[MANUAL] and the
original size key you
touched are highlighted.
If you wish to select an AB size, touch the
[AB/INCH] key and then touch the desired
original size key.
[AB] is highlighted and
AB size keys are
displayed. To return to
the INCH palette, touch
the [AB/INCH] key once
again.
If the original size is a non-standard size,
touch the [SIZE INPUT] tab and then enter
the X (width) and Y (length) dimensions of
the original with the
or key.
The X dimension (width)
is initially selected.
Touch the Y (
) key
and enter the Y
dimension (length).
The range of original
sizes that can be
entered is as follows.
3 Touch the [OK] key.
You will return to the initial screen.
4 The selected original size appears in the
top half of the [ORIGINAL] key.
Using the
reversing single
pass feeder
Using the
document glass
X (horizontal
direction) 5-3/4" to 17"
(143 to 432 mm)
2-1/2" to 17"
(64 to 432 mm)
Y (vertical
direction) 5-1/8" to 11-3/4"
(130 to 297 mm)
2-1/2" to 11-3/4"
(64 to 297 mm)
AUTO
AUTO
ORIGINAL
EXPOSURE
STANDARD SIZE SIZE INPUT
INCH
AB
OK
5 X 8
5 X 8 R
8 X 11R
8 X 11
8 X 13
8 X 14
11 X 17
1 / 2
1 / 2
1 / 2
1 / 2
1 / 2
1 / 2
1 / 2
1 / 2
A5
B5
A5R
A4
B4
A3
STANDARD SIZE SIZE INPUT
INCH
AB
OK
A4R
B5R
(2 1/2 11 3/4)
inch
(2 1/2 17)
inch X
Y
X
Y
STANDARD SIZE SIZE INPUT
17
11
OK
AUTO
ORIGINAL
EXPOSURE
X 5 Y10 1
2
1
8
ApollonII_general-copy_SEC.book 8 ページ ２００４年９月６日 月曜日 午後４時５７分