SATO DR300 - Manual (Page 22)

DR300 Operator Manual
20
• Close Cover.
Stop Position Adjustment
The correct stop position for dispense mode is the position where label is 2-3mm on
backing paper. Adjust OFFSET (VR) to obtain correct stop position.
• There may be cases when the dispenser does not function properly due to the
thickness of the labels used.
• Printing accuracy at peeling is V (Vertical) direction ± 1.5 mm, label size
direction ± 1.0mm.
• Dispenser unit is effective for label pitch 25-181mm. However, label size
limitation may vary with application conditions.
• Labels over 100mm may curl at dispense due to the nature of the material.
There is no remedy for this.
Chapter 4 - Setting of Label and Carbon Ribbon