SATO DR300 - Manual (Page 45)

DR300 Operator Manual
43
4) Count up 10 place of code with <LINE> key and set with <FEED> key.
(With <LINE> key, +1 count up from 0 to f is displayed)
5) Cursor moves to 1 place after set.
6) Count up 1 place with <LINE> key and set with <FEED> key.
7) After setting STX, advance to ETX setting. Hereafter, each code is set
accordingly to the same procedures for STX setting.
8) Display returns to top of service mode, after setting.
*Code data for the time of factory is default
STX : 7 b h
ETX : 7 d h
ESC : 5 e h
ENQ : 4 0 h
CAN : 2 l h
CODE ADJ
STX : 7 B
CODE ADJ
STX : 7 B
CODE ADJ
STX : 7 B
CODE ADJ
ETX : 7 D
SERVICE
LVL SET
Chapter 8 - Operation Panel