SATO DR300 - Manual (Page 47)

DR300 Operator Manual
45
[10] Factory Mode
To enter this mode, set DIPSW 2-5 to ON position. Open thermal print head, power on
while pressing both <FEED> and <LINE> keys. Release both keys when buzzer beeps.
The LCD display will show “HEAD OPEN” message, close the thermal print head and
“FACTORY MODE” will be displayed. Set DIPSW 2-5 top OFF position.
NON ALL HEAD CUT
Press <LINE> key to confirm the clear item.
Press <FEED> key to print a test sample.
Press <FEED> key to stop/pause printing.
FACTORY
MODE
FACTORY
NON
FACTORY
PRINT
ALL, HED, CUT
Chapter 8 - Operation Panel