SATO DR300 - Manual (Page 44)

DR300 Operator Manual
42
**
Time (hour, minute, second) can
incremented by pressing <LINE>
key and confirm by pressing
<FEED> key.
[8] Setting Non-Standard Protocode
1) Power on printer while holding down <LINE> and <FEED> keys.
2) Push <FEED> key 2 times and <LINE> key 5 times.
3) It advances to non-standard code setting by pushing <FEED>. Key. STX is
displayed first. The displayed data at this time becomes presently set code data.
(Setting sequence is STX-ETX-ESC-ENQ-CAN)
SERVICE
LVL SET
FEED key
TME 0 0 : 0 0
8 0 / 0 1 / 0 1
TME 0 0 : 0 0
8 0 / 0 1 / 0 1
TME 0 0 : 0 0
8 0 / 0 1 / 0 1
TME 0 0 : 0 0
8 0 / 0 1 / 0 1
FEED key
FEED key
FEED key
SERVICE
LVL SET
FEED key
DEFAULT
NO YES
CODE ADJ
CODE ADJ
STX : 7 B
Chapter 8 - Operation Panel