Sharp AR-650 - Manual (Page 58)

54
16. ALL CLEAR KEY
When you want to set the copy modes over again, or after a copy run has finished, pressing
the ALL CLEAR key returns the copier to the default copy modes. The default modes are the
status when the “READY” message is shown after the power is turned ON. The following modes
are set as default modes:
. Copy quantity “1”
. Reproduction ratio “100%”
. Photo/Text mode
. Automatic exposure
. Automatic paper selection
. Continuous-feed mode
. Non-sort mode (if the optional finisher is installed)
Using the ALL CLEAR key
Press the ALL CLEAR key.
. The display on the control panel returns to
the default modes.
1
Tip: The copier returns to the default copy
modes after 45 seconds even if the ALL
CLEAR key is not pressed.
1 2 3
4 5 6
7 8 9
0 C
ALL CLEAR
STOP
START
CLEAR