Ski-Doo WAKE Series - Manual (Page 65)

CONTROLS/INSTRUMENTS/EQUIPMENTS
smo2008-001-047_a
TYPICAL
1. Propulsion system connections
Proceed with the installation of the
other ballast tank.
Then, ballast tanks are ready to be
filled.
To Fill
Ballasts are filled by jet pump pressure.
Watercraft will need to move forward
in order to fill the ballasts.
WARNING
NEVER fill only one ballast tank,
uneven added weight of the bal-
last could affect the handling char-
acteristics of the watercraft.
Close ballast tank drain plug.
smo2008-001-050_a
TYPICAL
1. Drain plug
Position both ballast tank valves to ON
position.
smo2008-001-043_a
1. Valves location
ssi2008-001-303_a
TYPICAL
1. Port side tank
2. Starboard side tank
With engine running and shift lever
in forward position, depress throttle
lever to increase watercraft speed, bal-
last tanks will start to fill up.
Continue filling until water come out
from tanks overflow holes.
smo2008-001-049_a
TYPICAL
1. Overflow holes
Ballast system is now ready to be
used.
NOTE: Leave ballast tanks valve in
the ON position, this will ensure tanks
maximum water capacity while riding.
_______________
63