Ski-Doo WAKE Series - Manual (Page 96)

STORAGE AND PRESEASON PREPARATION
sbs2008-005-001_a
1. Intake hose (from intercooler)
2. Throttle body
2. Start and rev up the engine to
4000 RPMs several times.
sbs2008-005-002
WATER EXPELLED FROM INTERCOOLER
3. Stop engine.
4. Liberally lubricate throttle body in-
side and out.
5. Clean off any lubrication on the
throttle body intake hose flange.
6. Install air intake hose to the throttle
body.
Throttle Body Lubrication
Lubricate throttle body with XP-S Lube
or an equivalent.
Use fitting for that purpose provided in
the engine compartment.
With the engine not running, make
sure to spray lubricant at least 3 to 5
seconds for proper lubrication.
smo2008-001-051_a
MODELS WITHOUT AN ENGINE COVER
1. Fitting
smo2008-001-052_a
MODELS WITH AN ENGINE COVER
1. Fitting
Exhaust System Protection
In areas where temperature may
freeze, water trapped in the exhaust
system and intercooler must be re-
moved.
Using the flushing connector on jet
pump support, inject pressurized air
(around 689 kPa (100 PSI)) into system
until there is no more water flowing
from jet pump.
94
______________