Ski-Doo WAKE Series - Manual (Page 118)

TECHNICAL GUIDELINES
ENGINE LACKS ACCELERATION OR POWER (cont’d)
3. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM in SPECIAL PROCEDURES.
4. Clogged injectors.
– Refer to an authorized Sea-Doo dealer.
5. Low fuel pressure.
– Refer to an authorized Sea-Doo dealer.
6. Water in fuel.
– Siphon and replace.
7. Engine damaged by water ingestion.
– Refer to an authorized Sea-Doo dealer.
WATERCRAFT CAN NOT REACH TOP SPEED
1. Jet pump water intake clogged.
– Clean. Refer to SPECIAL PROCEDURES section.
2. Damaged impeller or worn-out wear ring.
– Replace. Refer to an authorized Sea-Doo dealer.
3. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM in SPECIAL PROCEDURES.
4. Faulty supercharger and/or intercooler (supercharged models).
– Refer to an authorized Sea-Doo dealer.
5. O.P.A.S. side vanes do not go up while watercraft is at speed
(models with sliding vanes).
– Clogged water pick up, square rings damaged, leakage in hoses or mechani-
cal malfunction. Refer to an authorized Sea-Doo dealer.
6. O.P.A.S. side vanes do not go down while engine is at idle
(models with sliding vanes).
– Broken spring inside side vane cylinder. Refer to an authorized Sea-Doo
dealer.
O.P.A.S. SYSTEM FAULTS (MODELS WITH SLIDING VANES)
1. Watercraft is more responsive than usual while turning.
– Side vanes do not go up while watercraft is at speed. Refer to an authorized
Sea-Doo dealer.
2. Watercraft pulls on one side.
– One side vane does not go up while watercraft is at speed. Refer to an autho-
rized Sea-Doo dealer.
3. O.P.A.S. side vanes do not go up while watercraft is at speed.
– Clogged water pick up, square rings damaged, leakage in hoses or mechani-
cal malfunction. Refer to an authorized Sea-Doo dealer.
116
______________