Ski-Doo WAKE Series - Manual (Page 36)

PRE-RIDE INSPECTION
Hull
Inspect hull for cracks or damage.
Jet Pump Water Intake
Remove weeds, shells, debris or any-
thing else that could restrict the flow
of water and damage propulsion unit.
Clean as necessary. If any obstruction
can not be removed, refer to an autho-
rized Sea-Doo dealer for servicing
F18J04Y
2 1
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
WARNING
When operating the engine while
the watercraft is out of the water,
the heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
Bilge
Should water be present in the bilge,
tilt the watercraft to the rear and un-
screw drain plugs to completely empty
the bilge.
Secure bilge drain plugs.
WARNING
Make sure drain plugs are properly
secured prior to launching the wa-
tercraft in water.
Battery
WARNING
Verify tightness of battery cables
to their posts and condition of bat-
tery retaining fasteners. Do not
charge or boost battery while in-
stalled.
All Models Except GTI and RXP
Battery is located under seat in bilge.
1
F18H0AY
TYPICAL
1. Battery
GTI and RXP Models
Battery is located under storage bin in
front storage compartment.
34
_______
SAFETY INFORMATION
________