Maintenance procedures, Engine oil, Recommended engine oil – Ski-Doo WAKE Series User Manual

Page 89: 130 and 155 engines, 215 and 255 engines, Engine oil level, If watercraft is out of the water, Models with engine cover, Models without an engine cover, Warning

Advertising
background image

MAINTENANCE PROCEDURES

Engine Oil

Recommended Engine Oil

Use XP-S SUMMER GRADE OIL
(P/N 293 600 121).

130 and 155 Engines

If the XP-S engine oil is not available,
use a 5W 40 engine oil meeting the
requirements for API service classifi-
cation SM, SL or SJ. Always check the
API service label certification on the oil
container, it must contain at least one
of the above standards.

215 and 255 Engines

If XP-S engine oil is not available, use a
5W 40 engine oil compatible with wet
clutches.

NOTE: The XP-S engine oil has been
thoroughly tested to be free of any
additives that could impair the func-
tionality of the supercharger clutch.

NOTICE

Do not use an engine oil

meeting the requirement for API ser-
vice classification SM or SL. Using
a lubricant not compatible with wet
clutches will impair the proper oper-
ation of the supercharger clutch. Do
not add any additives to the recom-
mended oil.

Engine Oil Level

NOTICE

Check

level

frequently

and refill if necessary. Do not over-
fill. Operating the engine with an
improper level may severely dam-
age engine.

WARNING

Certain components in the engine
compartment may be very hot.
Direct contact may result in skin
burn.

Oil level can be checked either with
watercraft in water or out of water.

If Watercraft is Out of the Water

1. Watercraft must be level. Raise

trailer tongue and block in position
when bumper rail is level.

2. Install a garden hose to the flushing

connector. Refer to

FLUSHING

in

POST-OPERATION CARE

and fol-

low the procedure.

NOTICE

Never run engine without

supplying water to the exhaust sys-
tem. Failure to cool exhaust system
may severely damage it.

NOTICE

Never run engine longer

than 5 minutes. Drive line seal has
no cooling when watercraft is out of
water.

3. With the engine already at normal

operating condition, let engine idle
for 30 seconds then stop engine.

4. Wait at least 30 seconds then pull

dipstick out and wipe clean.

smo2007-002-005_a

MODELS WITH ENGINE COVER

1. Oil dipstick

smo2007-002-007_a

MODELS WITHOUT AN ENGINE COVER

1. Oil dipstick

_______________

87

Advertising
This manual is related to the following products: