SANRAD I3.1.1205 - Manual (Page 307)

Appendix: Sample Configurations A-7
STEP 11. C REATE S TRIPED VOLUME (RAID 0)
Use the CLI command volume create striped to
create a striped volume, Stripe1.
volume create striped –vol Stripe1 –nbc 2 –sus 64
–ch Mirror1 –ch Mirror2
STEP 12. C REATE I SCSI TARGET AND LUN
After creating the final virtual volume
configuration that you want to expose to the
network host, you need to create an iSCSI target
for the volume as well as attach LUN0 to the
target volume. Use the CLI command volume expose
-new to create the iSCSI target and attach LUN0 to
the striped volume, Stripe1.
volume expose -new –vol Stripe1 –ta storage –tn
sanrad.billing. –device VSwitch
STEP 13. C ONFIGURE HOST STATION INITIATOR
Open the Microsoft iSCSI initiator program on host station 1.
Figure A-3. Microsoft iSCSI Initiator