Sony 4-144-907-43(1) - Manual (Page 108)

108 GB
D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\090OTH_GB.fm masterpage: Left
STR-DA3500ES
4-144-907-43(1)
For details on the Auto Calibration, see “9:
Calibrating the appropriate speaker settings
automatically (Auto Calibration)” (page 44).
See “Before you perform the Auto
Calibration” (page 45) before performing the
Auto Calibration.
To operate on the receiver
1 Press GUI MODE repeatedly to select
“GUI OFF”.
2 Press AMP.
Receiver operation is enabled.
3 Press MENU.
4 Press V/v repeatedly to select “<AUTO
CAL>”, then press .
5 Press V/v repeatedly to select “A.CAL
START”, then press to start the
measurement.
Measurement starts in five seconds. A
count down is displayed.
Note
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
6 Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
To cancel Auto Calibration
The measurement will be canceled when you
do the following:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Connect the headphones.
– Press GUI MODE.
Tips
• Operations other than turning the receiver on or off
are deactivated during Auto Calibration.
• In the following situations, the measurements may
not be performed correctly or Auto Calibration
cannot be performed.
– when special speakers, such as dipole speakers
are connected.
– when the multi zone function is used in zone 2/
zone 3.
To confirm/save Auto
Calibration when GUI function
is turned off
1 Confirm the measurement result.
When the measurement ends, a beep
sounds and the measurement result appears
on the display window.
Performing Auto Calibration
Measurement
result Display
window Explanation
When the
measurement
process
completes
properly COMPLETE Proceed to step
2.
When the
measurement
process fails E-
xxx:xx See “Message
list after Auto
Calibration
measurement”
(page 49).