Sony 4-144-907-43(1) - Manual (Page 119)

119 GB
D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\100REM_GB.fm masterpage: Right
STR-DA3500ES
4-144-907-43(1)
Using the
Remote
Setting remote control
codes that are not stored
in the remote
Even if a remote control code is not one of the
presets stored in the remote, it is possible for
the remote to learn the code using the learning
function.
Note
When setting up the receiver to learn the remote
command modes, replace the batteries with new
ones.
* To store a new command on one of those
buttons, press SHIFT beforehand.
1
While holding down RM SET
UP, press THEATRE.
The RM SET UP button lights up.
2
Press the input button
(including the TV button) for the
component you want to operate
with the new command.
The input button flashes. (The RM SET
UP button remains lit.)
3
Press the button on which you
want to store the new
command. For the buttons with
an asterisk in the illustration
above, press SHIFT, then press
the button.
The input button you selected in step 2
lights up. (The RM SET UP button
remains lit.)
4
Point the remote code receiver
section of the remote towards
the receiver/transmitter on the
remote control to be learned
from.
5
Press the button on the remote
commander to be learned from
to transmit the remote code.
While the remote of the receiver is
receiving the signal, the input button
selected in step 2 turns off.
The RM SET UP button flashes twice,
then the learning process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform the process again from step 2.
?/1
Input
buttons
RM SET
UP
THEATRE
SHIFT
Buttons
used to
learn
code*
TV
Buttons
used to
learn
code
About 5 cm - 10 cm
continued