Sony DMX-R100 - Manual (Page 14)

14
Automation Operation
Automation Operation
General
Before using the automation on any control for the first
time, it is wise to clear automation data which may be
resident in memory if the system has been in use by
others. The following assumes that all important
project data has been saved in an open slot in the Title
Manager.
To Clear Automation Data
1
Touch the {AUTOMATION} label in the middle at
the bottom of the GUI to display the
AUTOMATION GUI.
2
Touch the {MAKE STATIC} tab in the upper part of
the GUI.
Automating Faders
AUTOMATION GUI displaying MAKE STATIC option
3
Touch the {ALL ON} button to highlight all channel
and signal paths green. Or touch individual
buttons relating to channels and outputs, if more
appropriate, to highlight them green.
4
Touch {EXECUTE} under the MAKE STATIC
label. A confirmation pop-up will appear. Touch
{YES} to complete the operation
Dynamic and Snapshot automation
It is important to note that it is possible to dynamically
automate individual controls as well as to restore
snapshots, both to timecode. This could cause conflict
when, for example, the same control is restored from a
snapshot whilst also being controlled dynamically.
Therefore it is advisable to isolate controls from
dynamic automation when they are included in