Sony DMX-R100 - Manual (Page 8)

8
Automation Operation
Automation Operation
To Enter a New Cue at the Current Timecode
Point
To enter a Cue for the start of the material, for
example:
1
Whilst the material is either stationary or moving,
touch {NEW} in the CUE GUI, and a new entry will
appear in the TIMECODE column. A default
number will be entered automatically in the CUE
NAME column.
2
To change the default number to an appropriate
name, touch the default in the CUE NAME
column, and the QWERTY Keyboard pop-up
appears.
3
The default will be displayed in the upper entry
dialogue line. Either touch {BACK SPACE} several
times to delete it, or touch and move a finger
across it to highlight it. Then type in a suitable
name, such as ‘START OF TITLE’ in this case,
using the touch QWERTY keyboard. Touch
{ENTER} when finished.
To Revise the Time of a Cue ‘On the Fly’
1
Under the NUMBER column, touch the Cue
number to be revised. It highlights white.
2
Whilst the material is either stationary or moving,
touch {STORE} in the CUE GUI, and the current
timecode point will appear in the TIMECODE
column.
To Revise the Time of a Cue Manually
1
Under the TIMECODE column, touch the
timecode number to be revised. It highlights
white.
2
Then adjust the timecode number using the jog
wheel or the ten-number key pad. Press {ENTER}
at the bottom right of the number key pad when
finished.
To Locate to a Cue
1
Under the NUMBER column, touch the Cue
number that is to be the locate point, to highlight it
white.
2
Touch {LOCATE} in the CUE GUI and the system
will locate to the timecode point for the highlighted
Cue.
3
To locate to the same Cue, either touch {LOCATE}
or press the LOCATE button above the transport
keys on the panel.
Note
The front panel LOCATE button will always cause a locate
operation to the point set by touching {LOCATE} in the GUI,
even if another Cue number is touched and highlighted
white in the GUI. However, touching {LOCATE} in the GUI
will always locate to the Cue which is highlighted. In other
words, touching {LOCATE} in the GUI sets the Cue to which
the front panel LOCATE button will operate.
Cycle All
To play the source material from beginning to end and
have it repeat until the stop transport key
p is pressed:
1
Touch {CYCLE ALL} in the CUE GUI and it turns
green. The LOCATE button above the transport
keys on the panel also lights green.
2
Press the LOCATE button and the system will play
from the first Cue to the last Cue and repeat until
the
p transport key is pressed.
3
After pressing p, press {LOCATE} again to
continue Cycle All.
4
De-select {CYCLE ALL} when finished.
Note
When {LOCATE} in GUI is pressed for the first time or Cycle
All is continued, the system will always play from CUE 1.
Press the z transport key to continue from the current point.
Cycle Between Two Cues
To play the source material from one Cue to another
and have it repeat until the stop transport key
p is
pressed: