Sony DMX-R100 - Manual (Page 26)

26
Automation Operation
Automation Operation
To Automate All EQ Sections
The R100 allows the automation to be set up in order
to record data from sections of all channels and signal
paths on a global basis. Using the EQ section as an
example, first display the CHANNEL GUI, then:
1
Press {ABS} (short for absolute) on the panel under
the TC AUTOMATION heading above the
timecode display. The AUTO button in the middle
at the top of the GUI turns red and indicates ‘ABS’
at the lower left. In this mode the exact fader
positions and moves will be recorded.
2
Make sure the defaults ‘BUTT’ and ‘NORMAL’
are displayed in the AUTO button. If not, touch it
for a pop-down, which requires an individual
operation for each selection.
3
Touch {READY SETUP} to highlight it, and then
{OPTIONS} next to it for a pop-down. Touch
{ALL EQs} in the pop-down and then {CLOSE} to
finish with the pop-down menu. The {WRITE}
buttons for all channels and signal paths which
include EQ processing will flash, indicating
automation ready mode.
Global automation ready set-up exists for other
controls and sections as below. They are selected
using the {OPTIONS} pop-down:
• {ALL DYNAMICSs} for all channels and signal
paths which include Dynamics processing.
• {ALL AUX KNOBS} for the Aux Send Levels for
all channels.
• {ALL AUX BUTTONS} for the Aux Send Cuts for
all Channels and the Aux Returns.