Sony DMX-R100 - Manual (Page 32)

32
Automation Operation
Automation Operation
3
To change the default number to an appropriate
name, touch the default in the CUE NAME
column, and the QWERTY Keyboard pop-up
appears.
4
The default will be displayed in the upper entry
dialogue line. Either touch {BACK SPACE} several
times to delete it, or touch and move a finger
across it to highlight it. Then type in a suitable
name, such as ‘START OF TITLE’ in this case,
using the touch QWERTY keyboard. Touch
{ENTER} when finished.
To Revise a Snapshot
1
Under the NUMBER column, touch the Snapshot
number to be revised. It highlights white.
2
Whilst the material is either stationary or moving,
touch {STORE} in the SNAPSHOT GUI, and the
Snapshot location will be overwritten with the
current settings.
To Delete a Snapshot
1
Under the NUMBER column, touch the Snapshot
number to be deleted. It highlights white.
2
Whilst the material is either stationary or moving,
touch {DELETE} in the SNAPSHOT GUI. A pop-
up requesting confirmation will appear. Touch
{YES} to complete the operation.
This Snapshot location is now available for storing
a New Snapshot by touching {NEW} in the GUI.
To Recall a Complete Snapshot
1
Under the NUMBER column, touch the Snapshot
number to be recalled. It highlights white.
2
Whilst the material is either stationary or moving,
touch {RECALL} in the SNAPSHOT GUI and the
settings will be restored. Touch {UNDO} to reverse
the operation.
To Recall a Partial Snapshot
1
Under the NUMBER column, touch the Snapshot
number to be recalled. It highlights white.
2
Under the ISOLATE heading, touch individual
buttons relating to channels and outputs to
highlight them green. The data for these channels
will not be restored. Or, if more convenient, touch
the {ALL ON} button to highlight all and then de-
select individual channels.
3
Alternatively, under the FUNCTION heading,
touch ‘section’ buttons according to what is to be
isolated on a mixer-wide basis:
• {IN ROUT} for all Input Routing assignments.
• {EQ/FILT} for all Equaliser and Filter sections.
• {DYN} for all Dynamics sections.
• {AUX SND} for all Aux Send controls.
• {CUT} for all Channel, MTR and Aux Return
Fader Cuts.
• {ASSIGN} for all MTR and Program Bus Assign
buttons.
• {PAN} for all Channel and MTR Pans.
• {FADER} for all Channel, MTR and Aux Return
Faders.
• {INPUT} for all Input Trim and Delay settings.
4
Whilst the material is either stationary or moving,
touch {RECALL} in the SNAPSHOT GUI and the
settings will be restored. Touch {UNDO} to reverse
the operation.