Sony DMX-R100 - Manual (Page 24)

24
Automation Operation
Automation Operation
Automating Sections of Controls
To Automate a Complete EQ Section
To set up automating of complete sections of channels
on a channel by channel basis, using the EQ section as
an example, first display the CHANNEL GUI, then:
1
Press {ABS} (short for absolute) on the panel under
the TC AUTOMATION heading above the
timecode display. The AUTO button in the middle
at the top of the GUI turns red and indicates ‘ABS’
at the lower left. In this mode the exact fader
positions and moves will be recorded.
2
Make sure the defaults ‘BUTT’ and ‘NORMAL’
are displayed in the AUTO button. If not, touch it
for a pop-down, which requires an individual
operation for each selection.
3
Touch {READY SETUP} to the right of the AUTO
button and it highlights.
4
Touch {EQ/FILT} under the ‘READY SETUP’
heading to the lower right of the GUI. All EQ
knob readouts will turn from green to yellow and
yellow bars will appear beneath all EQ related
switches, indicating that the complete EQ section
is ready for automation data to be recorded. The
channel {WRITE} button will also flash.
Other sections set for automation in the same way:
• {DYNAMICS} button for the full Dynamics
section.
• {ASSIGN} button for all MTR and Program Bus
Assign buttons.
• {AUX SEND} button for all Aux Sends.