Silex technology WLAN MODULE SX-550 - Manual (Page 26)

Page 20 silex Using the SX-550 WLAN Module
Part Number 40183-101
Using the Wired Ethernet Method
To use wired Ethernet method:
1. Connect the Ethernet cable to the RJ-45 jack. This disables the wireless card.
2. Connect the power supply plug to the SX-550 Evaluation Daughtercard.
3. Power on the power supply.
When a link is established, the yellow and green LEDs on the module should begin blinking.
4. Continue to the Access silex Console Interface section.
Access silex Console Interface
You can access the silex Console Interface using a terminal program, such as Windows HyperTerminal.
To access HyperTerminal:
1. On a Windows computer, click START and select
Programs>Accessories>Communications>HyperTerminal. The Connection Description window
displays.
2. Type any name for the connection, then click OK. The Connect To window displays.
3. In the Connect Using list box, select a connection, then click OK. The default is COM1.
The COM Properties window displays.
4. On the Port Settings tab, select the settings shown in Table 12, then click OK.
Table 12 Port Settings
Parameter Setting
Bits per Second 115200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
5. Press Return until the Local> prompt displays. No user name is necessary.
Now you are ready to enter console commands. For a list of the console commands, refer to
Appendix A:
Console Commands