SUPER MICRO Computer 5010E - Manual (Page 122)

S UPER S ERVER 5010H/5010E Manual
B-8
Checkpoint Code Description
9Bh Returned after setting the RS-232 base address. Performing any required
initialization before the Coprocessor test next.
9Ch Required initialization before the Coprocessor test is over. Initializing the
Coprocessor next.
9Dh Coprocessor initialized. Performing any required initialization after the
Coprocessor test next.
9Eh Initialization after the Coprocessor test is complete. Checking the extended
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
command next.
A2h Displaying any soft errors next.
A3h The soft error display has completed. Setting the keyboard typematic rate
next.
A4h The keyboard typematic rate is set. Programming the memory wait states
next.
A5h Memory wait state programming is over. Clearing the screen and enabling
parity and the NMI next.
A7h NMI and parity enabled. Performing any initialization required before
passing control to the adaptor ROM at E000 next.
A8h Initialization before passing control to the adaptor ROM at E000h completed.
Passing control to the adaptor ROM at E000h next.
A9h Returned from adaptor ROM at E000h control. Performing any initialization
required after the E000 option ROM had control next.
Aah Initialization after E000 option ROM control has completed. Displaying the
system configuration next.
Abh Uncompressing the DMI data and executing DMI POST initialization next.
B0h The system configuration is displayed.
B1h Copying any code to specific areas.
00h Code copying to specific areas is done. Passing control to INT 19h boot
loader next.