SUPER MICRO Computer 5010E - Manual (Page 3)

Preface
About This Manual
This manual is written for professional system integrators and PC techni-
cians. It provides information for the installation and use of the Super-
Server 5010H/5010E. Installation and maintainance should be performed by
experienced technicians only.
The SuperServer 5010H/5010E is a high-end single processor 1U rackmount
server based on the SC810 1U rackmount server chassis and the Super
370SSR+ (for the 5010H), or the 370SSE+ (for the 5010E) mainboard. The
370SSR+/370SSE+ mainboard supports single Pentium III FCPGA 600 MHz-
1GHz processors and Celeron FCPGA/PPGA 300-700 processors and up to
512 MB SDRAM main memory.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with
the server system and describes the main features of the SUPER 370SSR+/
370SSE+ mainboard and the SC810 chassis, which make up the Super-
Server 5010H/5010E.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer
5010H/5010E into a rack and check out the server configuration prior to
powering up the system. If your server was ordered without processor
and memory components, this chapter will refer you to the appropriate sec-
tions of the manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions
and information provided by the control panel on the chassis as well as
other LEDs located throughout the system.
iii
Preface