SUPER MICRO Computer 5010E - Manual (Page 96)

S UPERSERVER 5010H/5010E User's Manual
7-24
BIOS
Plug & Play OS
Choose the No setting for computers that do not meet the Plug and Play
specifications, which will allow the BIOS to configure all the devices in the
system. Choosing the Yes setting lets the operating system configure PnP
devices that are not required for boot up (if the system has a PnP operating
system). The operating system would have the ability to change interrupt,
I/O, and DMA settings. Normally, this option is set to "Disabled".
Reset Configuration Data
Choosing the Yes setting will cause the PnP configuration data in the BIOS
to be cleared on the next boot up. Choosing the No setting does not force
PnP data to be cleared on the next boot.
7-6 PCI PnP Setup
Choose PCI/PnP Setup from the AMIBIOS Setup main menu. All PCI/PnP
options are described in this section. The PCI/PnP Setup screen is shown
below.
BIOS SETUP UTILITY
Main Advanced Chipset PCIPnP Power Boot Security Exit
Plug & Play O/S
Reset Config Data
PCI Latency Timer
Allocate IRQ to VGA
Palette Snooping
PCI IDE BusMaster
OffBoard PCI/ISA IDE Card
OffBoard PCI IDE Primary
IRQ
OffBoard PCI IDE Secondary
IRQ
USB Controller
Legacy USB Support
PCI Slot1 IRQ Preference
PCI Slot2 IRQ Preference
PCI Slot3 IRQ Preference
PCI Slot4 IRQ Preference
[No]
[No]
[64]
[Yes]
[Disabled]
[Disabled]
[Auto]
[Disabled]
[Disabled]
[Enabled]
[Disabled]
[Available]
[Available]
[Available]
[Available]
No: lets the BIOS
configure all the
devices in the system.
Yes: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
↔
Select Screen
↑↓
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
V02.03 (C)Copyright 1985-2000, American Megatrends, Inc.