SUPER MICRO Computer 5010E - Manual (Page 42)

5-4
S UPER S ERVER 5010H/5010E Manual
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors.
See Figure 5-1 for the pin locations of the various front control panel
buttons and LED indicators. Please note that even and odd numbered
pins are on opposite sides.
All JF1 wires have been bundled into a single ribbon cable to simplify
this connection. Make sure the red wire plugs into pin 1 as marked on
the board. The other end connects to JP4 of the Control Panel PCB
board, located just behind the system status LEDs on the chassis.
The control signals are all on the even numbered pins. See pages 5-
12 to 5-14 for details and pin descriptions.
In addition to the 2-pin Power LED header on JF1, there is a 3-pin
header for the same function at J50 on the motherboard, which is
located near JF1.
Figure 5-1. Control Panel Header Pins
Power Button (pins 1-2)
JF1
Overheat LED (pins 7-8)
1
NIC1 LED (pins 11-12)
Reset Button (pins 3-4)
2
X (Key)
NIC2 LED (pins 9-10)
HDD LED (pins 13-14)
Power LED (pins 15-16)
Control
Reset
Power
Power
Power
Power
Power
Power
Ground
Control
Control
Control
Control
Control
Control
Power
Control
x
J50
Power LED