Sony RM-VL1400T - Manual (Page 14)

14 GB
If the Remote Commander does not
seem to be working properly
If the learned button does not operate properly, clear the
learned signal first (page 14), then perform the learning
procedure from step 1 again. (For example, if the volume
becomes very loud after pressing the 2 (volume) +
button just once, noise may have interfered during the
learning procedure.)
For accurate learning
• Do not move the remote units during the learning
procedure.
• Be sure to press and hold the button of the other remote
control until you hear the confirmation beep.
• Use fresh batteries in both remote control units.
• Avoid learning in places under direct sunlight or strong
fluorescent light, or near a plasma display. (It may
cause noise interference.)
• The remote control signal direction may differ
depending on the remote control. If Learning does not
work, try changing the position of the remote control.
• When you programme the Remote Commander from a
remote control unit with an interactive signal exchange
system (supplied with some Sony receivers and
amplifiers), the response signal of the component may
interfere with the Learning of the Remote Commander.
In such a case, move to another room, etc., where
signals will not interfere.
IMPORTANT
Be sure to place the Remote Commander out of
the reach of small children or pets.
Also, set the Hold function to lock all the buttons on the
Remote Commander (page 11) when it is not used. Devices
such as air conditioners, heaters, electric appliances, and
electric shutters or curtains receiving an infrared signal can
be dangerous if misused.
Changing or clearing the function of
a “learned” signal
To change the “learned” function, clear it first and
perform the learning procedure again.
1
While pressing the (light) button, press
the OTHER button.
“SET MODE” appears as the screen title.
2
Press the V/v buttons to select “2
LEARN”, then press the OK button or the
centre Label select button.
“LEARN” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
3
Press the COMPONENT select button or
Label select button you want to clear the
learned signal from.
The selected A/V component’s label appears in the
second line on the screen.
4
While pressing the button on the Remote
Commander you want to clear the learned
signal from, press the
(light) button.
A beep sounds and the cleared button name and
“OK” appear on the screen.
Tip
If you press again the button which you cleared the learned
signal from while pressing the
(light) button, the label of
the button function and name will be initialized.
5
To clear the learned signals from other
buttons, repeat steps 3 and 4.