Sony RM-VL1400T - Manual (Page 33)

33 GB
Problem
A Component Macro does not
function correctly.
The display turns off
automatically.
The set mode closes
unexpectedly while setting.
The confirmation beep does
not sound.
The confirmation beep sounds
even though beep sound is set
to off.
“E” appears in the screen.
The Remote Commander does
not enter set mode.
Solution
• When programming a Component Macro, programme the actions in the correct order
(page 18).
• Change the direction of the Remote Commander. If it does not improve, position the
Remote Commander closer to each A/V component.
• Check that the programmed A/V components are ready to receive the signals correctly
(page 18).
• If you changed the preset code or programmed remote signals after programming the
Component Macro, the new signal will be transmitted when executing the Component
Macro.
• The interval between programmed steps is too short. See “To check the programmed
steps of a Component Macro and add a delay action” (page 19) to extend the interval,
or change the order of the steps.
The Remote Commander is preset at the factory to turn off the display automatically if
you do not operate it for over 30 seconds (automatic-off time). You can change the
automatic-off time between 1-60 seconds (page 26).
The set mode closes if you do not operate the Remote Commander for over 60 seconds.
Perform the next step within 60 seconds.
Beep sound is set to off. Set it on (page 27).
A confirmation beep sounds during set mode, even if the beep sound is set to off.
The batteries are weak. Replace them with new ones.
If “E” appears on the screen, the Remote Commander cannot enter into the set mode.
Replace the batteries with new ones.