Sony RM-VL1400T - Manual (Page 26)

26 GB
Setting the display
You can change the setting of the display. The Remote
Commander is preset at the factory to turn off the display
automatically if you do not operate it within 30 seconds.
You can also change the brightness of the display.
1
While pressing the (light) button, press
the OTHER button.
“SET MODE” appears as the screen title.
2
Press the V/v buttons to select “5 UNIT
SETTINGS”, then press the OK button or
the centre Label select button.
“UNIT SETTINGS” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
3
Press the V/v buttons to select “5 DISP.
OFF TIME”, then press the OK button or
the centre Label select button.
“DISP. OFF TIME” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
4
Press the B/b buttons or the left or right
Label select button.
You can set the automatic-off time from 1 to 60
seconds. Each time the button is pressed, the time
decreases/increases by 1 second.
5
Press the (light) button, centre Label
select button, the OK button, or the
RETURN button.
“UNIT SETTINGS” appears as the screen title.
6
Press the V/v buttons to select “6 DISP.
BRIGHTNESS”, then press the OK button
or the centre Label select button.
“DISP. BRIGHTNESS” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
7
Press the B/b buttons or the left or right
Label select button.
You can set the brightness from 1 to 3. Each time the
button is pressed, the level decreases/increases by 1.
8
Press the (light) button or the RETURN
button three times.
The set mode closes, and the Remote Commander
returns to standby for operating the A/V components.