Sennheiser evolution wireless series EM 100 - Manual (Page 21)

Using the receiver
20
To switch the receiver to standby mode :
To completely switch the receiver off :
̈
Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with
the receiver. During synchronization, the following parameters are trans-
ferred to the transmitter:
̈
Keep the STANDBY button
²
pressed until “ OFF ” appears on
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the STANDBY button
²
will
cancel your entry (ESC function) and return you to the current stan-
dard display.
Setting Transferred parameters
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver
(“
Inactive ”/“ Active ”)
It is vital to observe the notes on frequency selection on page 42.