Sony KDP 65XBR2 - Manual (Page 30)

Setting Up the Projection TV
20
Connecting a VCR and Cable Box
Use this hookup if
❑
Your cable TV company scrambles some channels, but not all of
them (pay channels vs. regular cable channels), so you need to
use a cable box
❑ You want to use the Twin View or Scrolling Channel Index
feature.
With this setup you can
❑
Use the projection TV remote control to change channels using
your cable box when the signal is scrambled.
❑ Use the projection TV remote control to change channels using
your projection TV when the signal is not scrambled. (Your
projection TV’s tuner provides a better signal than the cable box.)
❑ Use the Twin View and Scrolling Channel Index features.
❑ Record both regular cable TV and scrambled channels.
To connect a cable box and a VCR, you will need
❑
A small inexpensive device known as a splitter.
❑ Three short coaxial cables.
❑ Either a combination audio/video cable, or an S VIDEO cable
and audio cables.
1 Connect the CATV cable to the single (input) jack of the splitter.
2 Use a coaxial cable to connect one of the two output jacks of the
splitter to the projection TV’s CABLE jack.
3 Use a coaxial cable to connect the other output jack of the splitter
to the input jack of the cable box.
4 Use a coaxial cable to connect the output jack of the cable box to
the input jack of the VCR.
5 Use the video line (yellow) of a combination audio/video (A/V)
cable to connect the video output jack of the VCR to the video
input jack of the projection TV.
6 Connect the left (white) and right (red) audio output channels of
the VCR to the respective input jacks on the projection TV.
✍
If your VCR has an S VIDEO jack, you can substitute an S VIDEO cable for
the video line of an A/V cable. The S VIDEO cable will provide improved
video signal quality.