Sennheiser WiCOS - Manual (Page 65)

63
Configuring the conference system
To switch the test mode off:
̈
Click “ Test LEDs OFF ”.
The indicators and displays of the initialized conference units go off.
Initializing the conference units with the access point – “Init Units“
There are two ways to initialize the conference units with the access point:
• automatic initialization – “ Open access “
• manual initialization – “ Manual ” (recommended when operating
several WiCOS conference systems simultaneously and/or conference
systems with encryption)
̈ In the main navigation, click “ Conference management ” > “ Init units ”.
The “ Init units ” overview screen appears.
The following information is displayed:
To automatically initialize all conference units within the transmission
range of the access point:
̈
In the “ Init Control ” box, select the “ Open Access ” option button.
If you switch on a conference unit that is within the transmission range
of the access point, the conference unit is automatically integrated into
the conferences system. This conference unit is listed under “
Units
Initialized ” and “ Unit monitoring ”.
Information Function/Meaning
“ Units initialized “ Number of conference units that are initialized with the
access point and currently switched on
“ Units in Init List “ Number of conference units that are manually initialized
with the access point
CAUTION! Intermodulations in conferences!
If you operate several conference systems simultaneously in
“
Open Access ” mode, this will cause intermodulations as the
conference units will communicate with different access
points.
̈
Initialize the conference units manually (see next section).