Sennheiser WiCOS - Manual (Page 82)

Integrating WiCOS into a wired conference system
80
Slave mode operation with an
interpretation system
Configuring the interpretation system
For how to configure the interpretation system and how to use the
SDC 8200 ID interpreter units, refer to the instruction manual of the
SDC 8200 conference and interpretation system and to the instruction
manual of the SDC 8200 SYS-M and SDC 8200 SYS PC control software.
Depending on the settings of the SDC 8200 conference and interpretation
system, you have to adapt the following configuration of the access point
to your interpretation system:
̈
Set the maximum number of interpretation channels “ Number of
Interpretation channels ” (see page 60).
The WiCOS conference system can process up to 16 interpretation
channels. In slave mode operation, the number of interpretation
channels also affect the maximum number of simultaneously active
microphones of the wireless conference units (see page 60).
Listening to the interpretation channels
For how to listen to interpretations using the WiCOS CV and WiCOS DV
conference units, refer to page 35.
WiCOS AP
WiCOS AP
Computer
SDC 8200 ID
interpreter units
SDC 8200 CU/CU-M
WiCOS DV
WiCOS CV
SDC 8200 conference units