Sanyo PJ LINK PLC-XU106 - Manual (Page 54)

54
Remote control
Lamp control
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary code
(Code ). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in Code , both the projector
and the remote control must be switched to Code .
To change the code for the projector:
Select either Code 1 or Code  in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Note:
• When different codes are set on the projector and on the
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the code
on the projector.
• If the batteries are removed from the remote control for a
long period of time, the remote control code will be reset.
Setting
This function allows you to change brightness of the screen.
High .......... Brighter than the Normal mode.
Normal ...... Normal brightness
Eco ............ Lower brightness reduces the lamp power
consumption and extends the lamp life.