SIGMA EQ Station - Manual (Page 36)

34
UTILITY PAGE
Channel Recall
The Channel Recall features allow you to recall channel
settings from or on external devices.
MIDI Channel
Range: 1-16 or Omni
Defines on which MIDI channel the EQ station can receive
MIDI program change messages for channel recall.
Prog. Change
Off: - No response to MIDI program changes and no MIDI
program changes are sent at Channel recall.
In: - Individual channel settings can be recalled when an
incoming program change is received on the selected MIDI
channel according to the Map.
Out: - A program change is sent on the selectd MIDI
channel at channel recall.
In+Out: - See above. The described features on both In
and Out applies.
Bank no as channel:
Range: On/off
Any preset can be recalled into a channel. Which channel
to recall a preset into is set by sending a MIDI CC on the
LSB(controller 32) followed by a program change.
NOTE The Map parameters described below MUST be set
for any preset recall to be able to take place.This is due to
the organizing structure in folders as opposed to banks
where presets automatically have preset numbers
assigned.
Map From - Map to
An incoming MIDI program change message can be
mapped to recall channel settings from a specific preset.
“Map from” sets the incoming program change. “Map to”
sets the channel preset to recall.
Security
Key
Press OK to change security key. To change the current
key you must first type in the old key - then the new.
Level
No Lock: - The Lock functions are off.
Graph.EQ & Recall accessible: - Only the Graphic EQ and
recall functions are accessible.
Graph. EQ accesible: - Only the Graphic EQ is accessible.
Recall accessible: - Only recall functions are accessible.
Lock Unit: - The entire userinterface is locked unless you
have the correct 4 digit key.
To disable the lock functions without having the key:
• Power off EQ Station
• Press and hold FLAT and CHANNEL ON/OFF while
powering up the unit
Preset Copy function
The Preset Copy function allows you to copy presets from
the EQ Station you are opeartin to another.
How ?
First setup the conditions for the copy operation using the
following parameters, - then select “Copy” and press OK
Type
Use this parameters to select the type of preset to copy.
Seletc between: Channel, Scene or Folder.
When Folder is selected the entire folder will be copied.
Source
Is the name of the Channel, Scene or Folder you wish to
copy, depending on the selected Type - see above.
Dest. - Destination
Refers to the name of the EQ Station you wish to copy to.
Folder
If you are copying either a Channel or a Scene preset you
must set the destination folder on the EQ Station unit you
are copying to.
If you have chosen to copy a Folder you can only copy to
the root directory of the destnation unit as it is not possible
to save folders within folders.
System Reset
Default settings
Press OK and confirm to recall factory default settings.
Parameters in the Network and Device menu are NOT
recalled/reset and presets are also kept.
Delete all presets
Press OK and confirm to delete all presets on the device
you are operating. Presets on all other units in the network
are NOT affected.
UI Channel Sync
This parameter can be set to on/off on individual units.
Units in the network with this parameter set to “on” will
display the same channel information on all units.
On/Off button delay
When set to “on” the 4 on/off buttons on the left side of the
display will respond only if the buttons ar pressed for 1
second. This feature can prevent accidental on/off
switching of the effect blocks that could result in critical
level boosts or level drops.