SIGMA EQ Station - Manual (Page 37)

35
EDIT CONTROL
The ALL function is only affecting the Graphic EQ part of
the processing. When activated, changes on the Graphic
EQ will be done on ALL the EQ channels in the machine.
When in a network, up to all 64 channels will be selected
and adjusted.
When entering the page a flat filter setting is displayed.
Changes in the Gain setting will be applied to all channels
relatively to their current state. E.g. if a channel is set to
-3dB at 250Hz and 250Hz is moved to +2dB at the ALL
display, the new actual setting will be -1dB for the channel.
The changes on the ALL display are remembered until
power down, or until the Reset button is pressed and
confirmed using OK. When a reset is performed, the
display filter settings will be flattened, but without
performing changes on the other EQ channels settings.
ALL - Graphic EQ
Framerate
Via the Channel page a delay per channel can be set. The
Delay time is shown on the channel page in ms, feet,
meters and frames. The Framerate should be set
according to the connected devices.
LCD Light & LED Light
The display and the LEDs on the EQ Station are very
powerful. This you will enjoy especially at outdoor usage.
However, you may find the light too powerful when
operating e.g. in an indoor theater setup. Therefore the
LCD and LED lights can be dimmed individually.
Show Preset Name
On/ Off - Sets whether the preset name should be
displayed in the edit screens (Channel/Param EQ/Graph
EQ/DynEQ). Show preset name is set to “On” as default
but you may prefer to use the “Off” setting if you never use
presets and thereby get a “cleaner” look on the Edit pages.
GraphEQ graph:
It is possible to view the Graphic EQ settings either as
Bars, Curve or Bars & Curve
see page 23 for examples
GraphEQ width
Via the menu point “GraphEQ width”you can assign which
of the following three functions should be assigned to the
BANDWIDTH knob:
- Frequency: The function of the FREQUENCY knob is
duplicated to the BANDWIDTH knob.
- Sweep: Set a Gain and sweep this gain setting
through the frequencies using the the BANDWIDTH knob.
- Width: - Select width-mode and use the BANDWIDTH
encoder to select more than one frequency and cut or
boost the frequencies using the GAIN button.
- Curve: - Select curve-mode and use the BANDWIDTH
encoder to select more than one frequency. Cut and boost
frequencies in curves. +/-3dB peer 1/3 oct.
- Mirror: - Select mirror-mode and use the BANDWIDTH
and the GAIN encoder to mirror frequencies in O dB.