Sunwave Tech. SRC-7000 - Manual (Page 22)

SRC-7000 User’s Manual
20
If the codes are not correct please repeat steps and select
“All”. Repeat the ~ again to find the proper code for your
target device.
4. Finally, press the button to load the code and exit.
If you didn’t get the correct remote codes from the
“Pre-programmed code list” item, or you did the wrong steps,
please try the other ways to re-setup or supplement.
a. Use Pre-code function to load current remote codes.
(Please refer to 3.1.2 A. Pre-code P.23.)
b. Use Learning function to learn all or part of correct
remote codes. (Please refer to 3.1.2 B. Learning P.25.)
Now you are able to control your devices by the SRC-7000. For
more information about advanced operation functions, please go to
the next chapter.