Sunwave Tech. SRC-7000 - Manual (Page 74)

72
Appendix C
Troubleshooting Tables
Problem Solution
LCD does not show
anything when you touch it.
• Batteries may be dead.
• Replace the batteries with three new AAA Alkaline batteries.
• Check the batteries are properly insert with the + - indications.
• Reset the SRC-7000 by press the reset switch. (P.9 o.)
The SRC-7000 doesn’t
operate a device. • Make sure that the desired device on the SRC-7000 LCD panel
has been selected.
• Move SRC-7000 closer to the device. The maximum operating
distance is approximately 10 meters (30 feet).
• Ensure that you are aiming the SRC-7000 directly at the device
and there are no obstructions between the SRC-7000 and the
device.
• Ensure that you have correctly used the learning function to
configure the device or the Pre-Programmed Code has been
properly applied.
• Re-teach the malfunctioning key.
• The device has already plugged the power.
You cannot operate a
device even after teaching
the device by using the
learning function.
• Make sure that your SRC-7000 has correctly learned the target
device’s remote control code.
• Delete the device data from the SRC-7000 and carry out the
learning function again.
• Make sure you did not program more than one remote for a
given device.
You see an “error” display
on the LCD screen during
the learning procedure. • Make sure you hold the target remote’s key till the screen
displays OK or Error on the screen.
• Make sure the two remotes are not too close or too far apart –
keep them about 2~4 inches (5~10 cm) apart, and your device
remote control is aimed directly at the SRC-7000’s learning
eye.
• The batteries are sufficient with both SRC-7000 & the target
remote control.