Kenwood TH-D7E - Manual (Page 31)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
25
STA CON PACKET96BCONDUP
9 7 5
TONE FREQ. ID
This function scans through all tone frequencies to
identify the incoming tone frequency on a received
signal. You may use the function to find which tone
frequency is required by your local repeater.
1 Press [F], [2] (1 s) to activate the function.
• The Tone function is switched ON.
• If you access “F–2 (TONE FREQ)” using [UP]/ [DWN] in
Function Select mode, press [OK] (1 s) to activate the
function.
• To reverse scan direction, press [UP] (upward scan) or
[DWN] (downward scan).
• To quit the function, press [ESC].
• When the tone frequency is identified, the identified
frequency appears and blinks.
2 Press [OK] to program the identified frequency in
place of the currently set tone frequency.
• The previous frequency display is restored with the Tone
function remained ON. You may press [F], [1] to switch
the Tone function OFF.
• Press [ESC] if you do not want to program the identified
frequency.
• Press [UP]/ [DWN] while the identified frequency is
blinking, to resume scanning.
TH-D7 E 20 Operating through. 98.12.4, 0:11 PM 25