Konica Minolta MAXXUM 5D - Manual (Page 107)

107
LCD backlight
Enter
Reset default
Power save
MenuSec.Memory
Delete conf.
Clean CCD
LCD backlight
Reset default
After cleaning CCD,
turn camera off. Continue?
Yes No
The battery should be fully charged before cleaning the
CCD. If battery power is low, this function cannot be used.
The use of the optional AC adapter is recommended over
the use of the battery. Cleaning the CCD without sufficient
power will cause permanent damage.
Highlight “Enter” and press the center of the controller to
begin the cleaning routine.
Before the CCD is exposed, a confirmation screen appears;
choosing “Yes” executes opens the shutter and mirror, “No”
cancels the cleaning operation.
Remove the lens or body cap.
Use a blower brush to clean the CCD. Hold the body so it
is leaning forward to prevent the dust blown from the CCD
resettling in the camera. Do not touch the interior of the
camera. If the camera starts beeping, power is low.
Immediately stop cleaning and turn the camera off.
Turn the camera off to complete the operation. Replace the
lens or body cap.