KTM 250 EXC 2004 - Manual (Page 10)

ENGLISH
9
SPEED/TRP2 (trip 2) display mode
The TRP2 trip meter is always active and counts to 999.9. Contrary to
TRP1, the displayed figure can be changed using the + and – buttons. This
is a very useful function for trips taken according to a roadbook.
TRP2 is activated by the first impulse received from the wheel sensor and
stops automatically 3 seconds after the last impulse is received.
+ BUTTON increases the TRP2 figure
– BUTTON decreases the TRP2 figure
press the MODE BUTTON to change to the next mode
press and hold the MODE BUTTON 3 SECONDS to reset TRP2 to 0
SPEED/AVS2 (average speed 2) display mode
AVS2 shows the average speed based on the TRP2 and STP2 figures. The
calculation of this figure is activated by the first impulse received from the
wheel sensor and stops 3 seconds after the last impulse is received.
The displayed figure will deviate from the actual average speed if TRP2 was
changed manually or if STP2 was not stopped after the trip.
+
BUTTON no function
– BUTTON no function
press the MODE BUTTON to change to the next mode
press and hold the MODE BUTTON 3 SECONDS to change to the next mode
SPEED/STP2 (stop 2) display mode
STP2 is a manual stop watch. Start the stop watch by pressing the + but-
ton, press again to hold. Press again to continue timing.
Press the MODE button to change to the next mode. The STP2 display will
blink in the other modes if STP2 continues to run in the background. To
stop STP2, return to the SPEED/STP2 mode and press the + button.
+ BUTTON starts and stops the stop watch
– BUTTON no function
press the MODE BUTTON to change to the next mode
press and hold the MODE BUTTON 3 SECONDS to reset STP2 figures to 0
Setting the clock
To set the clock, switch the ignition off and select the SPEED/CLK mode.
Press and hold the MODE button for 3 seconds. The blinking digits can be
changed using the + and – buttons. Press the MODE button to move to the
next digit.
If no button is pressed for 20 seconds, the settings will be stored automati-
cally and the display will return to the SPEED/CLK mode.
+ BUTTON time +
– BUTTON time –
press the MODE BUTTON to change to the next digit
press and hold the MODE BUTTON 3 SECONDS to store the time and return to
the SPEED/CLK mode
Activating/deactivating the display modes
It may not be necessary to display all of the display modes (functions) at the
same time. It is possible to conceal any information not currently required.
By deactivating certain functions, the MODE button will only allow you to
select from the activated modes.
In the SPEED/H mode, press and hold the MODE button for 3 seconds to
access the SETUP menu. The blinking function can be activated by pressing
the + button and deactivated by pressing the – button.
If no button is pressed for 20 seconds, the setting will be stored automati-
cally and the display will return to the SPEED/H mode.
+ BUTTON activates the blinking display
– BUTTON deactivates the blinking display
press the MODE BUTTON to change to the next display without changing
any settings
press and hold the MODE BUTTON 3 SECONDS to store the settings and
change to the SPEED/H mode