English – KTM 250 EXC 2004 User Manual
Page 9
ENGLISH
8
SPEED/CLK (clock) display mode
CLK will display time in hours, minutes and seconds.
+
BUTTON
no function
–
BUTTON
no function
press the MODE
BUTTON
to change to the next mode.
press and hold the MODE
BUTTON
3
SECONDS
to set the time in the menu
(see SETTING THE CLOCK)
SPEED/H (hours) display mode
When you stop driving and no impulses are sent from the wheel sensor, the
display mode will automatically change from SPEED/ODO to SPEED/H. H
shows the operating hours. The operating hour counter starts to count as
soon as you start the engine. The displayed figure cannot be cleared.
Service intervals are indicated in operating hours for some KTM offroad
motorcycles, making the operating hour counter a very practical function.
+
BUTTON
no function
–
BUTTON
no function
press the MODE
BUTTON
to change to the next mode
press and hold the MODE
BUTTON
3
SECONDS
to change to the SETUP mode
(see REVEALING/CONCEALING functions).
SPEED/TRP1 (trip 1) display mode
The TRP1 trip meter is always active and counts to 999.9. It is used to mea-
sure the length of a trip or the distance between 2 refueling stops.
TRP1 is linked to AVS1 and STP1. The calculation of these figures is activa-
ted by the first impulse received from the wheel sensor (when the front
wheel starts to turn) and stops 3 seconds after the last impulse is received
(when the front wheel has stopped).
The TRP1, AVS1 and STP1 figures are automatically reset to 0 after passing
999.9.
+
BUTTON
no function
–
BUTTON
no function
press the MODE
BUTTON
to change to the next mode.
press and hold the MODE
BUTTON
3
SECONDS
to automatically reset the
TRP1, AVS1 and STP1 figures to 0.
SPEED/AVS1 (average speed 1) display mode
AVS1 is always active and shows the average speed based on the TRP1 and
STP1 figures. The calculation of this figure is activated by the first impulse
received from the wheel sensor and stops 3 seconds after the last impulse is
received.
+
BUTTON
no function
–
BUTTON
no function
press the MODE
BUTTON
to change to the next mode
press and hold the MODE
BUTTON
3
SECONDS
to reset the TRP1, AVS1 and
STP1 figures to 0.
SPEED/STP1 (stop 1) display mode
STP1 shows the traveling time based on TRP1 and continues to count whe-
never it receives impulses from the wheel sensor. The calculation of this
figure is activated by the first impulse received from the wheel sensor and
stops 3 seconds after the last impulse is received.
+
BUTTON
no function
–
BUTTON
no function
press the MODE
BUTTON
to change to the next mode
press and hold the MODE
BUTTON
3
SECONDS
to reset the TRP1, AVS1 and
STP1 figures to 0.