Kyocera S2410 - Manual (Page 63)

User Guide 55
13 Voice Commands
Voice commands allow you to call a contact, dial
a phone number, access menus, or find contact
information from your voice dial list.
Note: You cannot use voice recognition to end
a call; you must press the
End key when the flip
is open.
Voice dial list
To call or find a contact using voice dial you
must add the contact to your voice dial list.
The contact name must not have more than
three words or components in a contact name
for voice dialing recognition.
Add contacts
To add a contact to your voice dial list:
1.
Select Menu > Contacts > Voice Dial List .
2. At the contact list, highlight a contact
and press the
OK key. A check mark
appears next to a name when voice
dialing is active. Check each name you
wish use with voice dialing.
3. Select Save .
Remove contacts
To remove a contact from your voice dial list:
1.
Select Menu > Contacts > Voice Dial List .
2. At the contact list, highlight a check marked
contact and press the
OK key. No check
mark appears next to a name when voice
dialing is inactive. Uncheck each name you
wish removed from voice dialing.
3. Select Save .
Voice commands
Start voice commands
1. From the home screen, press the Send key to
initiate voice commands. The phone
prompts, “Say a command”.
2. Say one of the following commands and
following the voice prompts.
– “
Contact <name> ” call to a contact on
your voice dial list.
– “ Dial Number <number> ” call by
speaking the digits of the phone number.
– “ <shortcut name> ” sends you to a
menu item.
– “ Find Contact ” allows you to find a
contact from your voice dial list.
82-K8216-1EN.book Page 55 Monday, September 22, 2008 2:27 PM