Kyocera S2410 - Manual (Page 9)

User Guide 1
1 Getting Started
Phone battery
Install the battery
To install the battery:
1.
Hold the phone
face down.
2. Find notch directly
below the back cover. It
is square. Using your
thumbnail, lift the cover
to remove.
3. Place the battery in the
battery casing with the
metal contacts facing
toward the top of the
phone. The metal
contacts of the battery
must make contact with
the metal contacts of
the battery casing.
4. Replace the battery
door by lining up the
notches with the
openings at the top and on each side of the
battery casing.
5. Snap the cover into place.
Charge the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1.
Connect the AC adapter
to the microUSB jack on
the side of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the screen tells you whether
the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
You can safely recharge the battery at any time,
even if it has a partial charge.
Warning: The battery will not charge if you use
the phone while it is connected to an AC adapter.
Note: Before removing the battery, make sure the
phone is powered off.
82-K8216-1EN.book Page 1 Monday, September 22, 2008 2:27 PM