Kyocera Neo E1100 - Manual (Page 9)

User Guide 9
1 Get Started
Phone Battery
Install the Battery
To install the battery:
1. Hold the phone face
down.
2. Find notch directly
above the back cover. It
is square. Use the notch
to slide the cover down.
Lift the cover from the
bottom to remove.
3. Place the battery in the
battery casing with the
metal contacts facing
toward the bottom of
the phone. The metal
contacts of the battery
must make contact with
the metal contacts of
the battery casing.
4. Replace the battery
door by sliding the
notches into the openings on each side of the
battery casing.
5. Snap the cover into place.
Charge the Battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter
to the micro USB jack
on the side of the
phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the screen tells you whether
the phone is:
– Charging (the icon is animated)
– Partially charged
– Fully charged
You can safely recharge the battery at any time,
even if it has a partial charge.
Warning: The battery will not charge if you use
the phone while it is connected to an AC adapter.
Note: Before removing the battery, make sure the
phone is powered off.