Kyocera KM-P4850w - Manual (Page 10)

1-2
• If the floor is delicate against casters, when this product
is moved after installation, the floor material may be
damaged.
• During printing, some ozone is released, but the amount
does not cause any ill effect to one's health. If, however,
the printer is used over a long period of time in a poorly
ventilated room or when making an extremely large
number of copies, the smell may become unpleasant.
To maintain the appropriate environment for printing
work, it is suggested that the room be properly
ventilated.
■ Power supply/Grounding the printer
WARNING
• DO NOT use a power supply with a voltage other
than that specified. Avoid multiple connections in
the same outlet. These types of situations
present a danger of fire or electrical shock. .........
• Plug the power cord securely into the outlet. If
metallic objects come in contact with the prongs
on the plug, it may cause a fire or electric shock.
• Always connect the printer to an outlet with a
ground connection to avoid the danger of fire or
electrical shock in case of an electric short. If an
earth connection is not possible, contact your
service representative. .........................................
Other precautions
• Connect the power plug to the closest outlet possible to
the printer.
• The power supply cord is used as the main disconnect
device. Ensure that the socket/outlet is located/installed
near the equipment and is easily accessible.
■ Handling of plastic bags
WARNING
• Keep the plastic bags that are used with the
printer away from children. The plastic may cling
to their nose and mouth causing suffocation. .......
■ Environment
CAUTION
• Avoid placing the printer on or in locations which
are unstable or not level. Such locations may
cause the printer to fall down or fall over. This
type of situation presents a danger of personal
injury or damage to the printer. ............................
• Avoid locations with humidity or dust and dirt. If
dust or dirt become attached to the power plug,
clean the plug to avoid the danger of fire or
electrical shock.....................................................
• Avoid locations near radiators, heaters, or other
heat sources, or locations near flammable items,
to avoid the danger of fire. ...................................
• To keep the printer cool and facilitate changing of
parts and maintenance, allow access space as
shown below.
Leave adequate space, especially around the left
right and rear covers, to allow air to be properly
ventilated out of the printer. ..................................
• Always use the caster stoppers to stabilize the
printer once it is in place to keep it from moving
and/or falling over and causing injury. ..................
Other precautions
• Adverse environmental conditions may affect the safe
operation and performance of the printer. Install in an
air-conditioned room (recommended room temperature:
around 68
°F [20°C], humidity: around 65%RH) and
avoid the following locations when selecting a site for
the printer.
. Avoid locations near a window or with exposure to
direct sunlight.
. Avoid locations with vibrations.
. Avoid locations with drastic temperature fluctuations.
. Avoid locations with direct exposure to hot or cold air.
. Avoid poorly ventilated locations.
INSTALLATION PRECAUTIONS
Left:
>
= 11 13/16"
30 cm
Rear:
>
= 11 13/16"
30 cm
Right:
>
= 19 11/16"
50 cm
Front:
>
= 31 1/2"
80 cm