Kathrein UFD 540 - Manual (Page 43)

Adding and Removing Satellites
43
After pressing the

or

button, you are asked if you want to add the
satellites.
Confirm it with
.
The following message appears
You can now make the respective entries to your receiving system in
the corresponding positions using the

,

and

or

buttons
and exit the menu by pressing

three times. At the same time the
new station data is stored.
Entering satellite names
You can change the satellite name in the LNB configuration menu us-
ing the number buttons. Refer to section "Operating instructions" for
information about the exact procedure.
Removing satellites
To remove a satellite, select the "LNB configuration" menu, move the
cursor bar with

or

and confirm by pressing the

or

but-
ton. You will now be asked whether you wish to remove the satellite.
You can either confirm your selection with

or cancel with

.