Kathrein UFD 540 - Manual (Page 64)

Setting System Parameters
64
Tone burst
Under this menu point, the 22 kHz signal can be set as follows:
Switching statuses of setting: Switching statuses of setting: Switching statuses of setting:
22-kHz signal —> High/Low
and
Tone Burst —> Pos. A/B:
22-kHz signal —> Pos. A/B
and
Tone burst —> Opt. A/B
22-kHz signal —> Pos. A/B
and
Tone Burst —> High/Low
Low
High
22-kHz
22-kHz Off
On Pos Tone burst 22-kHz Low
High
Tone burst
Tone burst 0
1
Pos. 1
Pos. 2 Tone burst
Tone burst 0
1
1
2
3
4 0
0
1
1 Off
On
Off
On
Pos. 1
Pos. 2 22-kHz
22-kHz Off
On
DiSEqC
If the receiver is connected to a DiSEqC switching matrix, you will
need to set this menu point to ‘ON.’
The switching criteria and the input assignments of the DiSEqC
switching matrix must be maintained. Therefore, refer to the de-
scription of the switching matrices or contact the installer of the
receiving system.
DiSEqC Repeat
The DiSEqC command must be repeated if the receiver is operated
(cascaded) together with a receiving system with two or more DiSEqC
switching matrices connected in a series.
In this case, switch the menu point "DiSEqC repeat" to 1 or 2.
Factory setting: ‘OFF’
UFO mini
The input frequency of the receiver is fixed in a "user-controlled proc-
essing system". The signals from the "user-controlled processing sys-
tem" are transmitted on this frequency. The reception parameters for
programme selection are transferred to the receiving system by
means of a DiSEqC command and set accordingly.
The relevant setting, which needs to be selected, depends on the type
of "user- controlled processing system".
The setting should be made according to the data provided in the in-
stallation instructions for the "user-controlled processing system".
Remote frequency
If you have set the UFO mini menu point to ‘ON,’ you will need to set
the transmission frequency under this menu point.
Refer to the installation instructions of the "user-controlled processing
system" for the set transmission frequency.
Therefore, it is important to refer to the information provided in
the installation instructions of the "user-controlled processing
system".
UFO micro
The setting under this menu point is also designed for operation of the
receiver together with a processing system.
Control and communication between the receiver and the Kathrein
UFO micro system occur via the return path of the coaxial cable. ‘ON’
must be set under the UFO micro menu point, if the receiver is oper-
ated together with a UFO micro receiving system.
During installation, the receiving system assigns a special address to
the receiver so that the control instructions, which are sent from the