Kathrein UFD 540 - Manual (Page 65)

Setting System Parameters
65
receiver to the receiving system for signal selection, are also recog-
nised by this system.
A remote frequency must not be set in this operating mode, because
it is defined by the UFO micro system as part of the addressing pro-
cedure.
You will need to delete the previously allocated address when using
the receiver for the first time together with a UFOmicro receiving sys-
tem. You can do this under the UFOmicro menu point by selecting
"Reset" with the

buttons and pressing

.
The original factory setting is then allocated to the receiver. It must
then be reset to ‘ON.’ The receiver will then receive a new address
from the new system.
The pre-programming is not deleted with "Reset".
Presetting: ‘OFF’
Factory setting
Under this menu point, you can reset all the settings to the factory set-
ting by pressing

.
The factory settings need not necessarily correspond to the settings
required for your system!
After the reset, it may be necessary to repeat all settings.