Knoll Systems HT200 - Manual (Page 10)

Connecting Component Video Equipment withYCbCr output jacks to the RGB IN
connector
You can also connect the video
component to the RGB IN
connector, if the video
component has the component
video (YCbCr) signal jacks.
This connection may provide a
better picture quality than the
connections on page 9.
• You can switch the input
source to VIDEO, S-VIDEO,
or RGB.
• The AUDIO IN jack is for
equipment connected to the
RGB IN connector.
Before connecting
• Turn off the components that
are to be connected.
• The projector and computer
will be turned on in "Using
the Projector" on page 13.
Do not turn on either the
computer or unit until you
read this section.
• Please also refer to the
manual of the video
component to be connected.
If you are connecting a 5 wire
BNC cable to a 15 pin D-sub,
you may need three 21-131-0
BNC to RCA adaptors.
Connect the 15 pin D-sub into
the projector. Connect the red
BNC to the Cr output. Connect
the green BNC to the Y output.
Connect the blue BNC to the Cb output.
The remaining black and grey BNC connectors are not used in this case.
10